(a) (1) Lamps and reflex reflectors. As well as the safety issues, youâre likely to get pulled over sharpish if something isnât working. Brake lights. Killer2005. Table 1 specifies the requirements for lamps, reflective devices and associated equipment by the type of commercial motor vehicle.The diagrams in this section illustrate the position of the lamps, reflective devices and associated equipment specified in Table 1. 17,890 posts. If you do get pulled over by the police you may just get a verbal warning, but you could also get: A center brake light that is mounted higher than the two taillights. 189 months. with various words, ranging from a racing â¦ Can you offer a little advise, whats is the current standing on High Level brake lights (HLBL) or also known as 3rd brake light, normally placed in the top middle of your rear window. 2 Tail lights: 2 Turn signals: 2 Rear reflectors: 1 License plate light: 2 Rear side marker lights: 2 Rear side reflectors: 2 Front side marker lights: These functions are frequently combined into a single side marker light. Standards for brake lights and signal devices (a) Any motor vehicle may be equipped and when required under this article shall be equipped with the following signal lights or devices: (a) Hydraulic brake systems. Automakers often abbreviate this as CHMSL, or center high-mounted stop lamp. Each truck and bus manufactured on or after March 1, 1999 (except trucks and buses engaged in driveaway-towaway operations), and equipped with a hydraulic brake system, shall be equipped with an antilock brake system that meets the requirements of Federal Motor Vehicle Safety Standard â¦ § 20-129. 40-8-26 (2010) 40-8-26. Is that still legal? (a) When Vehicles Must Be Equipped. A stop lamp must emit a red or amber light, or any shade of color between red and amber. Key 'A' â Must stop within a specified distance 'B' â Not stated or no requirement 'C' â Supplemental brakes always required Federal Regulations Title 49 (49 CFR 571) of the Federal Motor Vehicle Safety Standards (10-1-08 Edition) defines a 'trailer' as follows: "'Trailer' means a motor vehicle with or without motive power, â¦ Required Lights; 2 Stop/brake lights: These functions are frequently found together in combination tail lights. 2 â¦ â Every vehicle upon a highway within this State shall be equipped with lighted headlamps and rear lamps as required for different classes of vehicles, and subject to exemption with reference to lights on parked vehicles as declared in â¦ Thanks. How many brake lights do i legally need on my car? Required lighting equipment of vehicles. (C) Notwithstanding any law to the contrary, an implement of â¦ If i have three but one is not working. § 40-8-26 - Standards for brake lights and signal devices O.C.G.A. The stop lamp shall be actuated upon application of the service (foot) brake and may be incorporated with one or more other rear lamps. A stop lamp must be visible from a distance of not less than 300 feet to the rear in normal sunlight. As far as your brake lights are concerned, make sure theyâre working and keep them clean. (1) Every motor vehicle, trailer, semitrailer, and pole trailer and any other vehicle which is being drawn at the end of a train of vehicles shall be equipped with at least one tail lamp mounted on the rear which, when lighted as required, emits a red light plainly visible from a distance of 500 feet to the rear. Such authorized light or lights may be displayed on any location on the vehicle or equipment, other than within the headlight assembly or grill area of the vehicle, in the tail light lamp or stoplight area, or factory installed emergency flasher and backup light area. Tuesday 31st July 2012. If a specialty product and accessory (e.g., a truck cap or a headache rack) covers a factory third brake light, it must have a new one built in. The question is drivers are now placing stickers which obscure (not block) the HLBL.